Channel Master 9537EU Istruzioni per gli Interventi Scaricare il pdf

Programmable Antenna Rotator Controller

with Infra-Red Remote Control

Owner’s Guide to Installation and Use

Model 9521A Drive and Controller, 117 VAC

Model 9521EU Drive and Controller, 230 VAC

Model 9537A Controller Only, 117 VAC

Model 9537EU Controller Only, 230 VAC

CAUTION: Read and adhere to all IMPORTANT SAFEGUARDS listed elsewhere in this

booklet. Read and observe safety, installation and operating instructions supplied with

this unit and with your antenna BEFORE installation or operation. Retain this booklet and

all instructions for your safety and future reference.

Controller Compatibility - If purchased separately, the Model 9537 controller may be used with the

following rotator drive units:

Channel Master

- Models 9500, 9510(A), 9512, 9513, 9515(A)

Radio Shack

- Model 15-1225

If you are upgrading an existing installation with Model 9537 controller, skip to “Model 9537

Programmable Controller” in this leaflet.

Drive Unit Installation

STEP 1 – Determine proper size number of rotator cable from chart. Three conductor cable is

suitable, but if four conductor cable is used, connect both conductors 3 and 4 to terminal 3 of the

terminal board.

Gage No. of Maximum Length

AWG MM Conductors Feet Meters

22 0,6 3 180 55

22 0,6 4* 200 61

20 0,8 3 280 85

20 0,8 4* 310 95

18 1,0 3 445 136

18 1,0 4* 510 155

*Attach 3 and 4 conductors to No. 3 terminals on control and drive.

STEP 2 – Install drive unit.On new drive units, arrow on mast support should be aligned with arrow shaped

mast stop on housing. Install drive unit with arrows pointing south. Using a short piece of mast (3 feet or

less), install the antenna to the drive unit aiming the antenna south.When desired channels are close to or

on opposite sides of the north end stops, the antenna may be installed pointing north. Note, however, that

the antenna will then be pointing in the opposite direction from that indicated on the control.

An alternative means of setting up is to perform a synchronization of the drive unit using the controller.Then

set up the antenna pointing north. Ensure power is disconnected from the controller when

making antenna adjustments.

1 2 3 4 5 6 7 8 9 10

Sommario

Pagina 1 - Drive Unit Installation

Programmable Antenna Rotator Controllerwith Infra-Red Remote ControlOwner’s Guide to Installation and UseModel 9521A Drive and Controller, 117 VACMode

Pagina 2 - Terminal Connections

DIRECTV®is a registered trademark of Hughes Communications.Dish Network is a registered trademark of Echostar Communications.Pioneer is a registered t

Pagina 3 - Model 9537

2Do not mount citizens band base station antennas on top of a standard mast mount drive unit.Mast support may become overloaded in high winds.STEP 3 –

Pagina 4

3Features:• 69 Programmable Antenna Locations (01-69) - Allows location number to be sameas channel number.• Digital Compass 000-360 degrees with dire

Pagina 5

4Controller Installation and SetupImportant Note! Before disconnecting old control box, make noteof each wire color and the corresponding terminal con

Pagina 6

5Operation From The Supplied Handheld Remote1. Install 2 AAA batteries in the handheld remote.2. Check operation by pressing the POWER button and obse

Pagina 7

68. SynchronizationPress the SYNC key on the front panel or 00 DOWN from the handheld. A counterclockwise move-ment is performed to synchronize the co

Pagina 8 - IMPORTANT SAFEGUARDS

7Appendix B Handheld Remote Control Command SummarySYNC: 00▼PROGRAM: #▲# (# = 01-69)DISPLAY MEMORIES/STATUS: 99▲AUTOSYNC ON/RESET TO 50: 98▲AUTOSYNC

Pagina 9

8IMPORTANT SAFEGUARDSYour antenna rotator unit, consisting of a control and a drive, has been engineered and manufacturedto assure your personal safet

Pagina 10

98. All individuals, especially children, should be cautioned about dropping or pushing objects into anyopenings. Some internal parts carry hazardous

Più documenti per Telecomandi Channel Master 9537EU

Per vedere il documento Channel Master 9537EU Istruzioni per gli Interventi

Channel Master 9537EU Istruzioni per gli Interventi (10 pagine)

Commenti su questo manuale

Nessun commento

Channel Master 9537EU Istruzioni per gli Interventi

Navigare online o scaricare Istruzioni per gli Interventi per Telecomandi Channel Master 9537EU. Channel Master 9537EU Operating instructions Manuale Utente

Sommario

Più documenti per Telecomandi Channel Master 9537EU

Commenti su questo manuale